Kia Optima Hybrid: Driveshaft and axle / Driveshaft Assembly

Front Hub / Knuckle Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove wheel nuts, front wheel and tire from front hub. Tightening torque: 88.2 ~ 107.8 N.m ...

Front Driveshaft Components and Components Location

Component location 1. Driveshaft (LH) 2. Driveshaft (RH) Components 1. BJ assembly2. Circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: IMS Control Switch Repair procedures


Inspection 1. Remove the IMS control switch connector (A). 2. With the IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the IMS control switch. Driver Power Seat Control Switch (For IMS) Removal 1. Disconnect ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Heated Oxygen Sensor (HO2S) Repair procedures


Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 4 and 5 [B1/S1]. Measure resistance between the HO2S terminals 3 and 4 [B1/S2]. 4. Check that the resistance is within the specification. HO2S [Bank 1/Sensor 1] (Linear type) ...

© 2021 Copyright www.koptimatfhev.com