Function |
1. |
Push the A button lower of the rear view mirror to turn on
the function of the compass mirror so that displays a sign of a
direction on the small board in the upper-right side of the mirror. |
2. |
Push the A button again to turn off its function. |
Inspection Check it by the procedure below to see if the function of the ECM is normal. 1. Turn the ignition key to the "ON" position. 2. Cover the front sensor to stop functioning. 3. Shine a light at ...
Calibration Procedure If the compass has been calibrated or set to variance zone number incorrectly, or you are driving in specific places (tunnel, parking lot in building, underground parking lot, near ...
Inspection 1. Remove the driver door trim. (Refer to the BD group - "Front door") 2. Remove the switch assembly connector (A) from the door trim. 3. Check for continuity between the terminal No.1 and No.2. NODescriptionNODescription1Fuel filler door B+3GND2Fuel filler door actuator4Trunk lid switch 4. ...
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). 3. Disconnect the injector connector (A). 4. Remove the wiring harness bracket mounting bolt (B). ...