Inspection |
1. |
Turn the ignition key to the "ON" position. |
2. |
Cover the front sensor to stop functioning. |
3. |
Shine a light at the rear sensor. |
4. |
The ECM should be darkened as soon as the rear sensor detects the light.
|
5. |
When the reverse gear is engaged, the ECM should not be darkened. |
6. |
When heading lights to both the front and rear sensors, the ECM should not be darkened. |
Removal |
1. |
Remove the mirror wiring cover (A). |
2. |
Disconnect the mirror connector (B) and remove the mounting screw (A). |
3. |
Slide the inside rear view mirror rearward to remove the inside rear view mirror assembly (A).
|
Installation |
1. |
Install the mirror assembly. |
2. |
Install the mirror wiring cover and connector.
|
Description The ECM (Electro Chromatic inside rear view Mirror) is for dimming the reflecting light from a vehicle behind at night, Preventing glare from the light. The forward facing sensor detects brightness ...
Function 1. Push the A button lower of the rear view mirror to turn on the function of the compass mirror so that displays a sign of a direction on the small board in the upper-right side of the mirror. ...
Specification ItemSpecificationCoil Resistance (?)13.8 ~ 15.2 [20°C(68°F)] ...
Removal 1. Disconnect the 12V battery negative (-) cable. 2. Remove the knob (A) and boots (B) by pulling the direction of arrow after removing the boots from the console upper cover. 3. Remove the floor console assembly. (Refer to Body - "Console") 4. Disconnect the main connector (A). 5. Disconnect ...