Kia Optima Hybrid: Automatic Transaxle Control System / Underdrive Brake Control Solenoid Valve (UD/B_VFS) Repair procedures

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Underdrive Brake Control Solenoid Valve (UD/B_VFS) Repair procedures

Inspection

1.	Turn ignition switch OFF.

Remove the air duct (A).

Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Remove the air cleaner assembly.

(1)	Disconnect the breather hose (A).

(2)	Disconnect the air intake hose (B) and then remove the air cleaner assembly (C).

Tightening torque:

Hose clamp bolt:

2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)

Air cleaner assembly bolts:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

•	When installing the air intake hose, the plate of the hose clamp must be in line with the stopper of the hose.

•	When installing the air intake hose, the center of the mark of hose must be in line with the throttle body rib.

4.	Remove the solenoid valve connector (A).

5.	Measure resistance between signal terminal and ground terminal.

6.	Check that the resistance is within the specification.

Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.

(Refer to Hydraulic System - "Valve Body")

Underdrive Brake Control Solenoid Valve (UD/B_VFS) Schematic Diagrams

Circuit Diagram ...

Overdrive Clutch Control Solenoid Valve (OD/C_VFS) Description and Operation

Description Overdrive clutch control solenoid valve(OD/C_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure to the overdrive clutch. ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Balance Shaft & Oil Pump Repair procedures

Removal Balance Shaft Module (BSM) Chain System 1. Remove the timing chain. (Refer to Timing system in this group) 2. Install a stopper pin (A) after compressing the balance shaft chain tensioner. 3. Remove the balance shaft chain hydraulic tensioner (B). 4. Remove the balance shaft chain tensioner arm ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Anchor Pretensioner (APT) Repair procedures

Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. To remove the seat belt anchor pretensioner (C), keep on pushing the lock pin (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B). 3. Remove the door scuff ...