 Troubleshooting
TroubleshootingTrouble Shooting Ignition System SymptomSuspect areaRemedyVehicle indicates Ready in dash, but engine will not run when requested by the HPCU (HEV module).Ignition coilInspect ignition coil, or replace ...
 Repair procedures
Repair proceduresOn-vehicle Inspection • Check that the auxiliary 12V battery cables are connected to the correct terminals. • Disconnect the auxiliary 12V battery cables when the battery is given a quick ...
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage the hub bolts when removing the rear wheel & tire. 2. Remove the sprit pin and castle nut and then disconnect the rear assist arm (A) from ...
Inspection 1. Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal50Cluster ion generator fault * Diagnostic procedure refer to DTC code. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad. (Refer to ...