| Inspection |
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the auto light sensor (A) from crash pad upper side by using screw (-) driver.
|
| 3. |
Remove the auto light connector. |
| Installation |
| 1. |
Reconnect the auto light connector. |
| 2. |
Install the auto light sensor. |
Auto Light Switch Repair proceduresInspection Lighting Switch Inspection With the multi function switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function ...
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel and reinforcing panel. (Refer to the Body group - crash pad) 3. Remove the shower duct (A). 4. Pull down steering column shaft after removing bolts and nuts. (Refer to the steering group ...
Specifications Fuel Delivery System ItemsSpecificationFuel TankCapacity65 lit. (17.2 U.S.gal., 68.7 U.S.qt., 57.2 Imp.qt.)Fuel FilterTypePaper typeFuel Pressure RegulatorRegulated Fuel Pressure333 ~ 353 kPa (3.4 ~ 3.6 kgf/cm?, 48.3 ~ 51.2 psi)Fuel PumpTypeElectrical, in-tank typeDriven byElectric motor ...