Circuit Diagram |
Inspection Glass Antenna Test 1. Wrap aluminum foil (A) around the tip of the tester probe (B) as shown. 2. Touch one tester probe to the glass antenna terminal (A) and move the other tester probe along ...
Inspection 1. Check the audio remote control switch (A) for resistance between connector terminals in each switch position. [LH-Audio] [LH-Mute] [Audio] SwitchConnector terminalResistance (±5%)Volume ...
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Disconnect the crankshaft position sensor connector (A). 3. Remove the protector (A). 4. Remove ...
Removal and Installation Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine tends to overheat. 1. Drain engine coolant so its level is below thermostat. 2. Disconnect the radiator lower hose ...