Inspection |
1. |
Ignition "OFF" |
2. |
Disconnect ambient temperature sensor. |
3. |
Check the resistance of ambient temperature sensor between
terminals 1 and 2 whether it is changed by changing of the ambient
temperature.
Specification
|
4. |
If the measured resistance is not specification, substitute
with a known-good ambient temperature sensor and check for proper
operation. |
5. |
If the problem is corrected, replace the ambient temperature sensor. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Loosen the mounting bolts and then remove the under cover (A). |
3. |
Disconnect the connector and then remove the ambient temperature sensor (A). |
4. |
Installation is the reverse order of removal. |
Description 1. The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, ...
Component Location ...
Special Service Tools Tool Name / NumberIllustrationDescriptionLower arm ball joint remover0K545-A9100Removal of front lower arm from front axle Personal Protective Equipment NameIllustrationDescriptionInsulation gloveUsed when inspecting or working on the high voltage components[Insulation performance ...
Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front passenger seat assembly. (Refer to the Body group - "Seat") 3. Remove the OCS assembly. (Refer to the Body group - "Seat") – There are several case about DTC, ...