Kia Optima Hybrid: Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Accelerator
Position
Output Voltage (V)
APS1
APS2
C.T
0.7 ~ 0.8
0.29 ~ 0.46
W.O.T
3.85 ~ 4.35
1.93 ~ 2.18

Accelerator Position Sensor (APS) Schematic Diagrams

Circuit Diagram ...

Fuel Tank Pressure Sensor (FTPS) Description and Operation

Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge control solenoid ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Description and Operation


Description Regeneration Brake System During deceleration or braking of an electric vehicle or HEV, the drive motor acts as an alternator and charges the battery by converting the vehicle’s kinetic energy generated during braking into electrical energy. Regenerative braking amount depends on the vehicle ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Power Seat Control Switch Repair procedures


Inspection With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. A : Power seat control switch B : Lumber support switchRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove ...

© 2025 Copyright www.koptimatfhev.com