Inspection |
Wiper Switch |
Washer Switch |
Removal |
1. |
Remove the steering column upper and lower shrouds after removing 3 screws. |
2. |
Remove the wiper switch (A) by releasing the part. |
3. |
If necessary of removing the wiper & washer switch (A),
release the lock of wiper switch using tool without removing the
steering wheel and the clock spring. |
Installation |
1. |
Install the wiper switch. |
2. |
Install the steering column upper and lower shrouds. |
Component Location 1. Windshield wiper arm & blade2. Wiper & washer switch3. Windshield washer hose4. Windshield wiper motor & linkage5. Washer motor6. Washer reservoir7. Wiper relay (Engine ...
Component Location 1. Cap2. Nut3. Wiper arm & blade4. Rivet5. Cowl top cover6. Bolt7. Wiper motor & linkage assembly ...
Description 1. Heater unit includes mode control actuator and temperature control actuator. 2. Temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. Signal from control unit adjusts position of temperature door by operating temperature switch ...
Inspection 1. Remove the cowl top cover. (Refer to the wiper) 2. Disconnect the windshield deicer connector (A) from the wiper motor linkage. 3. Check for continuity between the terminals of deicer lines. 4. Turn the ignition switch ON and the windshield deicer switch ON, then measure the voltage between ...