| Troubleshooting |
| Trouble Symptom | Probable cause | Remedy |
| Vehicle pulls to one side | Scoring of driveshaft ball joint | Replace |
| Wear, rattle or scoring of wheel bearing | Replace | |
| Defective front suspension and steering | Adjustment or Replace | |
| Vibration | Wear, damage or bending of driveshaft | Replace |
| Driveshaft rattle and hub serration | Replace | |
| Wear, rattle or scratching of wheel bearing | Replace | |
| Shimmy | Defective wheel balance | Adjustment or Replace |
| Defective front suspension and steering | Adjustment or Replace | |
| Excessive noise | Wear, damage or bending of driveshaft | Replace |
| Rattle of driveshaft and worn hub splines | Replace | |
| Wear, rattle or scoring of wheel bearing | Replace | |
| Loose hub nut | Adjustment or Replace | |
| Defective front suspension and steering | Adjustment or Replace |
Special Service ToolsSpecial Service Tools Tool Name / NumberIllustrationDescriptionBand installer09495 - 39100Installation of hook type boot band.Band installer09495 - 3K000Installation of ear type boot bandLower arm ball ...
Description The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The SRSCM must decide whether to deploy the restraint system or not. After determining that pretensioners ...
Description 1. Heater unit includes mode control actuator and temperature control actuator. 2. Temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. Signal from control unit adjusts position of temperature door by operating temperature switch ...