Kia Optima Hybrid: SRSCM / SRS Control Module (SRSCM) Description and Operation

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Restraint / SRSCM / SRS Control Module (SRSCM) Description and Operation

Description
The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The SRSCM must decide whether to deploy the restraint system or not. After determining that pretensioners and/or airbag deployment is required, the SRSCM must supply sufficient power to the pretensioners and airbag igniters to initiate deployment.
The SRSCM determines that an impact may require deployment of the pretensioners and airbags from data obtained from impact sensors and other components in conjunction with a safing function.
The SRSCM will not be ready to detect a crash or to activate the restraint system devices until the signals in the SRSCM circuitry stabilize.
It is possible that the SRSCM could activate the safety restraint devices in approximately 2 seconds but is guaranteed to fully function after prove-out is completed.
The SRSCM must perform a diagnostic routine and light a system readiness indicator at key-on. The system must perform a continuous diagnostic routine and provide fault annunciation through a warning lamp indicator in the event of fault detection. A serial diagnostic communication interface will be used to facilitate servicing of the restraint control system.
SRSCM

...

SRS Control Module (SRSCM) Components and Components Location

Components ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Manifold Absolute Pressure Sensor (MAPS) Specifications


Specification Pressure (kPa)Output Voltage (V)20.00.79 46.71.84101.34.0 ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: IMS Control Switch Repair procedures


Inspection 1. Remove the IMS control switch connector (A). 2. With the IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the IMS control switch. Driver Power Seat Control Switch (For IMS) Removal 1. Disconnect ...

© 2023 Copyright www.koptimatfhev.com