Description |
Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. (Refer to BD group) 3. Loosen the two STPS screws, then remove ...
Removal 1. Remove the cylinder head cover. 2. Set No.1 cylinder to TDC/compression. a. Turn the crankshaft pulley and align its groove with the timing mark "T" of the lower timing chain cover. b. Check that the mark(A) of the CVVT sprockets are in straight line on the cylinder head surface as shown in ...
High Voltage Shut-off Procedures Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries. • High voltage components: ...