Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Open the trunk and remove the trunk door trim.
(Refer to the BD group - "Trunk") |
3. |
Disconnect the back view camera connector(A). |
4. |
Pull down and remove the back view camera holder(A). |
5. |
Remove the back view camera (A) after pushing pins fixed the both of camera. |
Installation |
1. |
Fix the back view camera with the back view camera holder. |
2. |
Connect the back view camera connector. |
3. |
Install the trunk door trim.10
|
Circuit Diagram ...
ECM Terminal And Input/Output signal ECM Terminal Function Connector [C100-K] PinNo.DescriptionConnected to1Power groundChassis Ground2Battery power (B+)Ignition Switch3Power groundChassis Ground4Battery power (B+)Main Relay5Power groundChassis Ground6Battery power (B+)Battery 7-8-?9Fuel Level Sender ...
Components 1. Front muffler2. Catalytic converter3. Center muffler4. Main muffler5. Gasket6. Hanger ...