Components |
PSU must not be disassembled. |
1. Motor connecter 2. Bracket 3. Block | 4. Accumulator 5. Damper 6. Motor |
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air duct (A). 3. Remove air cleaner assembly (B). 4. Disconnect the brake fluid level switch connector (A), ...
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air duct (A). 3. Remove air cleaner assembly (B). 4. Disconnect the brake fluid level switch connector (A), ...
Tire wear 1. Measure the tread depth of the tires. Tread depth [limit] : 1.6 mm (0.063 in.) 2. If the remaining tread depth (A) is less than the limit, replace the tire. When the tread depth of the tires is less than 1.6 mm(0.063 in.), the wear indicators (B) will appear. ...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 4 and 5 [B1/S1]. Measure resistance between the HO2S terminals 3 and 4 [B1/S2]. 4. Check that the resistance is within the specification. HO2S [Bank 1/Sensor 1] (Linear type) ...