Inspection |
1. |
Remove the front door trim.
(Refer to the BD group - "Front door") |
2. |
Remove the front door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the rear door trim.
(Refer to the BD group - "Rear door") |
2. |
Remove the rear door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the trunk lid trim panel.
(Refer to the BD group - "Trunk lid") |
2. |
Disconnect the 3P connector from the actuator. |
3. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door") |
2. |
Remove the front door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table. |
1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door") |
2. |
Remove the rear door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check for continuity between the terminals in each switch position according to the table. |
1. |
Remove the trunk lid trim. |
2. |
Disconnect the 3P connector from the actuator. |
3. |
Check for continuity between the terminals in each switch position according to the table. |
Component Location 1. Driver power window switch2. Door lock switch3. BCM (Body Control Module)4. Front door lock actuator5. Rear door lock actuator6. Trunk lid open actuator7. SJB (Smart Junction Box) ...
Inspection Diagnosis With GDS 1. It will be able to diagnose defects of power door lock with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and self diagnosis. 2. Select ...
Side Body A Front side member tooling hole (O20)Fender apron tooling hole (O10)Front door upper hinge mounting hole (O13)Front door lower hinge mounting hole (O13)Fender panel mounting hole (O6.6)Rear door upper hinge mounting hole (O13)Rear door lower hinge mounting hole (O13)Rear door switch mounting ...
Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of the air temperature is needed because air density varies according to the temperature. So the ECM uses not only ...