Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front/rear bumper.
(Refer to Body - "Front Bumper cover")
(Refer to Body - "Rear Bumper cover") |
3. |
Disconnect the connector (A) from the sensor.
[Front] [Rear] |
4. |
Pull out the sensor (A) by opening the sensor holder (B) out.
[Front] [Rear] |
Installation |
1. |
Connect the connector, and then install the sensor. |
2. |
Install the bumper. |
Component ...
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the smart junction box cover. 3. Remove the crash pad side switch assembly (A) as shown below picture. Put on gloves to ...
Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms. ...
Troubleshooting SymptomsPossible CausesRemedyWarning illuminated"Check active air flap system"Active Air Flap System Fail(Flap stuck)• Inspect the flap and remove the foreign substance• Check the Active Air Flap assembly • Repair or replace as requiredActuator FaultReplace the actuatorMalfunction ...