Inspection Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function ...
Component Location 1. Horn switch2. Horn relay (Engine room compartment)3. Horn (Low)4. Clock spring5. Horn (High) ...
Inspection Front Seat Heater Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to the BD group - "Console") 3. Remove the seat heater switch connectors from the floor console upper cover (A). 4. Operate each seat heater switch and check that continuity ...
Replacement 1. Remove the cap (B) and remove the nuts, then remove the wiper arm (A). Tightening torque : 22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.5 lb-ft) 2. Disconnect the nozzle hose (B). 3. Detach the clips, then remove the cowl top cover (A). 4. Installation is the reverse of removal. ...