Kia Optima Hybrid: Back view camera System / Description and Operation

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Body Electrical System / Back view camera System / Description and Operation

Description

Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.

This system is a supplemental system that shows behind the vehicle through the AV monitor while backing-up.

This system is a supplementary function only. It is the responsibility of the driver to always check the inside/ outside rearview mirror and the area behind the vehicle before and during backing up because there are blind spots that can''t be seen through the camera.

Back view camera System

...

Components and Components Location

Component Location 1. Back view camera2. AVN monitor ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Camshaft Position Sensor (CMPS) Repair procedures

Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal • Do not remove the camshaft position sensor while engine is running or right after engine stops, or a scald by the flowed out engine oil may occur. [Bank 1 / Intake] ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: PWM Blower Module Repair procedures

Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. BLOWER speedManual VoltageAuto Voltage13.4Auto Low(4.5V)24.64.5~5.535.95.6~6.747.26.8~7.758.37.8~8.969.59.0~10.1711.310.2~11.38B+? ...