Replacement |
1. |
Remove the cap (B) and remove the nuts, then remove the wiper arm (A).
|
2. |
Disconnect the nozzle hose (B). |
3. |
Detach the clips, then remove the cowl top cover (A). |
4. |
Installation is the reverse of removal.
|
Replacement Outside Rear View Mirror Replacement • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent ...
...
Inspection 1. Ignition "ON" 2. Using the scan tool. 3. Emit intensive light toward photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and reduce with lower intensive light. 1. Auto Light Signal2. Auto Light Signal Signal3. Photo Signal ...
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the smart junction box cover. 3. Remove the crash pad side switch assembly (A) as shown below picture. Put on gloves to protect your hands. 4. Remove the PAS switch (A) after disconnecting the connector. Installation 1. ...