| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Remove the air duct (A).
|
| 3. |
Remove the air cleaner assembly.
|
| 4. |
Remove the solenoid valve connector (A).
|
| 5. |
Measure resistance between signal terminal and ground terminal. |
| 6. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
26 Brake Control Solenoid Valve(26/B_VFS) Schematic DiagramsCircuit Diagram ...
Line Pressure Control Solenoid Vale Description and OperationDescription Line pressure control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure to the line pressure. ...
Description 1. The maintenance-free battery is, as the name implies, totally maintenance free and has no removable battery cell caps. 2. Water never needs to be added to the maintenance-free battery. 3. The battery is completely sealed, except for small vent holes in the cover. After disconnecting ...
Components 1. Camshaft bearing cap2. Camshaft front bearing cap3. Exhaust camshaft4. Intake camshaft5. Exhaust CVVT assembly6. Intake CVVT assembly7. Exhaust camshaft upper bearing8. Intake camshaft lower bearing ...