Kia Optima Hybrid: Cooling System / Water pump Components and Components Location
| Components |
| 1. Water pump pulley 2. Dust cover 3. Water pump sub assembly (Water pump housing) 4. Water pump housing gasket 5. Water pump cover 6. Water pump gasket | 7. Water inlet pipe gasket (O-ring) 8. Water inlet pipe 9. Water temperature control assembly 10. Water temperature control assembly gasket A 11. Water temperature control assembly gasket B 12. Water inlet fitting | 13. Engine coolant temperature sensor 14. Thermostat 15. Thermostat gasket 16. Throttle body coolant hose |
Radiator Repair procedures
Inspection Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. 2. Apply a pressure of 93.16 ~ 122.58kPa (0.95 ~ 1.25kgf/cm?, 13.51 ...
Water pump Repair procedures
Removal and Installation 1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster. 2. Remove the water pump drive belt (A). (1) Put the SST ...
Other information:
Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Description and Operation
Limitations Of The Navigation system GPS Signal Reception State As the GPS satellite frequency is received/transmitted in straight lines, reception may not work if hiding devices are placed on or near the GPS antenna or when traveling through the following locations. • Tunnels • Basement parking ...
Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Engine And Transaxle Assembly Repair procedures
Removal • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. • To release the fuel system pressure before removing the engine assembly, start the engine with the fuel pump relay removed. ...