Kia Optima Hybrid: Automatic Transaxle Control System / Input Speed Sensor Description and Operation

Description
Input speed sensor is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the TCM. The sensor provides critical input data that''s used in feedback control, gear setting control, line pressure control, clutch activation pressure control, and sensor fault analysis.

Transaxle Oil Temperature Sensor Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Remove the air duct (A). Tightening torque: 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft) 3. Remove the air cleaner assembly. (1) Disconnect the breather hose ...

Input Speed Sensor Specifications

Specifications Type: Hall effect sensor Operation condition (°C)°F((-)40 ~ 150)) -40 ~ 302Air gap(mm)in.(0.95~1.65) 0.037 ~ 0.065 Output voltage(V)High1.18 ~ 1.68Low0.59 ~ 0.84 ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Knock Sensor (KS) Repair procedures


Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Drain the engine coolant (Refer to “Cooling System” in EM group). 3. Remove the radiator upper hose (Refer to “Cooling System” in EM group). 4. Disconnect the knock sensor connector (A). 5. Remove the ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Wheel Repair procedures


Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     When using an impact gun, final tightening torque should be checked using a torque wrench. Run out inspection 1. Jack up the vehicle. 2. Measure the wheel ...

© 2022 Copyright www.koptimatfhev.com