Description |
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal • Be sure to read and follow the “General ...
Specifications Direct control VFS [E/C] Control type : Normal low type Control Pressure kpa(kgf/cm?, psi)9.81 ~ 500.14(0.1 ~ 5.1, 1.42 ~ 72.54)Current value (mA)50~850 Internal resistance (?)5.1 ...
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. Remove the crash pad side switch assembly (A) as shown below picture. Put on gloves to protect your hands. 4. Disconnect the rheostat connector (A) from ...
Specification Ignition System ItemsSpecificationIgnition coilPrimary resistance0.62 ± 10 % (?)Secondary resistance7.0 ± 15 % (k?)Spark plugsTypeFXU16HR11Gap1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.) Charging System ItemsSpecificationAuxiliary 12V batteryType54-28GRCold cranking amperage [at -18°C(-0.4°F)]600AReserve ...