Kia Optima Hybrid: IMS (Integrated Memory) / Specifications

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Body Electrical System / IMS (Integrated Memory) / Specifications

Specifications

IMS Electrical System

Item	Specification
Rating voltage	DC 12V
Operating voltage	DC 9V ~ 16V
Operating temperature	-22°F ~ 176°F (-30°C ~ +80°C)
Maintaining temperature	-40°F ~ 185°F (-40°C ~ +85°C)
Max, humid	95%
Consumption current	MAX 700mA
Dark current	Below 2mA

Motor Electrical System

Item	Specification
Rating voltage	13.5V (Slide, Recline, Front height, Rear height)
Current	Slide : 8A
	Recline : 8A
	Front height : 7.5A
	Rear height : 7.5A
At worst current	Slide : 24A
	Recline : 20A
	Front height : 25A
	Rear height : 27A

Mechanical System

Item	Specification
Type	Motor with hall IC
Duty ratio	50 ± 15
Total stroke	Slide : 240mm
	Recline : 63°
	Front height : 32mm (Motor)
	Rear height : 52mm (Motor)
Total pulse number	Slide : 899
	Recline : 1,136
	Front height : 332
	Rear height : 412
Moving speed (Terminal voltage : 13.5V)	Slide (forward): 17.9mm or more Slide (backward): 20.2mm or more
	Recline : 3.5 °/ sec
	Front height : 7mm / sec or more
	Rear height : 7mm / sec or more

IMS (Integrated Memory)

...

Components and Components Location

Component Location 1. Seat Memory Unit (IMS)2. IMS control switch3. IMS driver power seat control ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Front Hub / Knuckle Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove wheel nuts, front wheel and tire from front hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the wheel nuts when ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Head Lamps Repair procedures

Inspection 1. Check-points upon head lamp failure (HID) (1) Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) (2) Check the fuse and relay. (3) Check the polarity of ballast. (If the polarity are changed, low beam doesn''t lighten) (4) Check the bulb connector securely. ...