Signal Waveform |
Circuit Diagram ...
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal • Be sure to read and follow the “General ...
Component Location 1. Windshield deicer relay (Built-in engine room relay box)2. Windshield deicer switch3. Windshield deicer4. Deicer connector ...
Inspection Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.Removal 1. Disconnect the negative (-) battery terminal. 2. Loosen 2 screws holding the overhead console (A). 3. Disconnect the connectors ...